Adjusting Copy Image Area; Printing; Adjusting Registration - Ricoh D127 Service Manual

4.14 ADJUSTING COPY IMAGE AREA

Adjust the copy image area under any of the following conditions:
1. After clearing engine data (SP5-801-001 or SP5-801-002).
2. After replacing any of the following components:

LED unit

Scanner motor

Polygon mirror motor

Paper tray

4.14.1 PRINTING

Make sure that the paper is correctly loaded in each paper tray before starting the adjustment
procedures in this section.

Adjusting Registration

Use the Trimming Area Pattern (SP2-109-001 > 10) for this adjustment.
1. Print out the test pattern with the paper fed from the regular paper tray.
2. Print out the test pattern with the paper fed from the by-pass tray.
3. Print out the test pattern by selecting duplex printing.
4. Measure the distance between the leading edge of the image area and the leading edge of
the paper [A].
SM
Adjusting Copy Image Area
4-57 D127/D128