Cannot Send Via Voip Gateway - Ricoh D127 Service Manual

11 Network bandwidth too narrow?
12 Remote fax cancelled transmission?

Cannot send via VoIP Gateway

Check Point
1 LAN cable connected?
2 VoIP Gateway T.38 standard?
3 VoIP Gateway installed correctly?
4 VoIP Gateway power switched on?
Is the IP address/host name of the
5
specified Gateway correct?
6 Number of the specified fax correct?
7 Firewall/NAT is installed?
8 Transmission sent manually?
9 IP address of local fax registered?
SM Appendix
Request the network administrator to
increase the bandwidth.
Raise the delay level.
IPFAX SW 01 Bit 0 to 3
IP-Fax bandwidth is the same as the
DCS speed. Set IP-Fax SW00 Bit 6 to
1.
Check whether the remote fax
cancelled the transmission.
Action
Check the LAN cable connection.
Contact the network administrator.
Contact the network administrator.
Contact the network administrator.
Check the IP address/host name.
Check the remote fax number.
Cannot breach the firewall. Send by
using another method (Fax, Internet
Fax)
Manual sending not supported.
Register the IP address.
4-25
IP-Fax Troubleshooting
D127/D128