Selecting Programs; Specifying Values; Activating Copy Mode; Quitting Programs/Ending (S) Sp Mode - Ricoh D127 Service Manual

Service Program

Selecting Programs


When you want to jump to the program directly, confirm the item "SP Direct" [A] selected and
put the SP number you want to operate by the keypad. Then press the "#" key [B].

When you want to select the program in the menu, touch the signs [C] to scroll through the
menu. Then touch the item you want to operate.

Specifying Values

1. After locating a program, type the keypad to put the number in as the value. To switch
between positive (plus) and negative (minus) values, press the
2. Press the "#" key [B] to confirm the value or the "C" key [D] to cancel.

Activating Copy Mode

You can activate the copy mode while the SP mode is running. When you do so, the copier
outputs images or patterns that help you adjust the SP setting.
1. Press the key [E]. The copy mode is activated.
2. Specify copy settings and press the
3. To return to the SP mode, touch the item "To SP" displayed on the upper left corner on the
panel.

You cannot end the SP mode while the copy mode is activated.

Quitting Programs/Ending (S) SP Mode

Touch the item "Exit" displayed on the upper right corner on the panel to quit the program or end
the SP mode.

Conventions used in the tables:


Asterisk (*): The settings are saved in the NVRAM. Most of them return to the default values
when you execute SP5-801-002. CTL indicates that the data is contained in NVRAM on the
controller board.

DFU: The program is for design/factory use only. Do not change the settings.

Brackets ([ ]): The brackets enclose the setting rage, default value, and minimum step with
unit ([Minimum to Maximum / Default / Step]).
D127/D128
key [E].
5-2
key.
SM