Ricoh D127 Service Manual page 464

Bit Switches
System Switch 09 [SP No. 1-101-010]
No FUNCTION
Confidential image option on
the result report
0
0: OFF
1: ON (Attached)
Condition selection for admin
communication report record
1
0: After image data Tx
1: After call connection
Automatic error report printout
2
0: Disabled 1: Enabled
Printing of the error code on
3 the error report
0: No 1: Yes
4 Not used
Power failure report
5
0: Disabled 1: Enabled
Conditions for printing the
protocol dump list
6 0: Print for all communications
1: Print only when there is a
communication error
D127/D128
COMMENTS
Selects images Attached/Not attached on the
accumulation/Tx result report for confidential Tx.
0: Communications that reached phase C
(message tx/rx) of the T.30 protocol are listed on
the Journal.
1: communications that reached phase A (call
setup) of T.30 protocol are listed on the Journal.
This will include telephone calls.
0: Error reports will not be printed.
1: Error reports will be printed automatically after
failed communications.
1: Error codes are printed on the error reports.
Do not change this setting.
1: A power failure report will be automatically
printed after the power is switched on if a fax
message disappeared from the memory when the
power was turned off last.
This switch becomes effective only when system
switch 00 bit 6 is set to 1.
1: Set this bit to 1 when you wish to print a protocol
dump list only for communications with errors.
5-12 SM Appendix