HP A5830 Configuration Manual page 195

[PE3-behavior-down_downlink] remark service-vlan-id 100
[PE3-behavior-down_downlink] quit
[PE3] qos policy down_downlink
[PE3-qospolicy-down_downlink] classifier down_downlink behavior down_downlink
[PE3-qospolicy-down_downlink] quit
# Configure an uplink policy up_uplink for network-side port GigabitEthernet 1/0/2 to substitute CVLAN
30 for the CVLAN ID of the outgoing traffic tagged with CVLAN 10 and SVLAN 200.
[PE3] traffic classifier up_uplink
[PE3-classifier-up_uplink] if-match customer-vlan-id 10
[PE3-classifier-up_uplink] if-match service-vlan-id 200
[PE3-classifier-up_uplink] quit
[PE3] traffic behavior up_uplink
[PE3-behavior-up_uplink] remark customer-vlan-id 30
[PE3-behavior-up_uplink] quit
[PE3] qos policy up_uplink
[PE3-qospolicy-up_uplink] classifier up_uplink behavior up_uplink
[PE3-qospolicy-up_uplink] quit
# Configure customer-side port GigabitEthernet 1/0/1 as a trunk port, assign it to VLAN 200, and apply
uplink policy down_uplink to the incoming traffic and downlink policy down_downlink to the outgoing
traffic on the port.
[PE3] interface gigabitethernet 1/0/1
[PE3-GigabitEthernet1/0/1] port link-type trunk
[PE3-GigabitEthernet1/0/1] port trunk permit vlan 200
[PE3-GigabitEthernet1/0/1] qos apply policy down_uplink inbound
[PE3-GigabitEthernet1/0/1] qos apply policy down_downlink outbound
[PE3-GigabitEthernet1/0/1] quit
# Set network-side port GigabitEthernet 1/0/2 as a trunk port, assign it to VLAN 200, and apply uplink
policy up_uplink to the outgoing traffic on the port.
[PE3] interface gigabitethernet 1/0/2
[PE3-GigabitEthernet1/0/2] port link-type trunk
[PE3-GigabitEthernet1/0/2] port trunk permit vlan 200
[PE3-GigabitEthernet1/0/2] qos apply policy up_uplink outbound
[PE3-GigabitEthernet1/0/2] quit
Configuring PE 4.
4.
# Configure an uplink policy test to add outer VLAN tag 200 to VLAN 30 tagged traffic.
<PE4> system-view
[PE4] traffic classifier test
[PE4-classifier-test] if-match customer-vlan-id 30
[PE4-classifier-test] quit
[PE4] traffic behavior test
[PE4-behavior-test] nest top-most vlan-id 200
[PE4-behavior-test] quit
[PE4] qos policy test
[PE4-qospolicy-test] classifier test behavior test
[PE4-qospolicy-test] quit
# Assign port GigabitEthernet 1/0/1 to VLAN 200.
188