HP A5830 Configuration Manual page 44

Configuring the global link-aggregation load-sharing criteria
To configure the global link-aggregation load-sharing criteria:
Step...
1. Enter system view
2. Configure the
global link-
aggregation
load-sharing
criteria
In system view, the switch supports the following load-sharing criteria and combinations:
Source IP address

Destination IP address

Source MAC address

Destination MAC address

Source IP address and destination IP address

Source IP address and source port

Destination IP address and destination port

Any combination of incoming port, source MAC address, and destination MAC address

Configuring group-specific load-sharing criteria
To configure load-sharing criteria for a link-aggregation group:
Step...
1. Enter system view
2. Enter Layer 2 aggregate
interface view
3. Configure the load-
sharing criteria for the
aggregation group
In Layer 2 aggregate interface view, the switch supports the following load-sharing criteria and
combinations:
Automatic load-sharing criteria determined based on the packet type

Source IP address

Destination IP address

Source MAC address

Destination MAC address

Destination IP address and source IP address

Destination MAC address and source MAC address

Command...
system-view
link-aggregation load-sharing
mode { { destination-ip |
destination-mac | destination-port
| ingress-port | source-ip |
source-mac | source-port } *
Command...
system-view
interface bridge-aggregation interface-
number
link-aggregation load-sharing mode { {
destination-ip | destination-mac |
source-ip | source-mac } * |
Remarks
—
Required
By default, Layer 2 packets are load-shared
based on the source/destination MAC
addresses and incoming ports; Layer 3
packets are load-shared based on the
source/destination IP addresses
Remarks
—
Required
Use either command
Required
The default load-sharing criteria
are the same as the global load-
sharing criteria
37