Setting An Example Layer 2 Static Aggregation Configuration - HP A5830 Configuration Manual

Setting an example Layer 2 static aggregation configuration

Network requirements
As shown in
Device A and Device B are connected through their respective Layer 2 Ethernet interfaces

GigabitEthernet 1/0/1 through GigabitEthernet 1/0/3.
Configure a Layer 2 static aggregation group on Device A and Device B, respectively. Enable VLAN

10 at one end of the aggregate link to communicate with VLAN 10 at the other end, and VLAN 20
at one end to communicate with VLAN 20 at the other end.
Enable traffic to be load-shared across aggregation group member ports based on the source and

destination MAC addresses.
Figure 8 Network diagram for Layer 2 static aggregation
VLAN 10
GE1/0/4
Device A
GE1/0/5
VLAN 20
Configuration procedure
Configure Device A
1.
# Create VLAN 10, and assign port GigabitEthernet 1/0/4 to VLAN 10.
<DeviceA> system-view
[DeviceA] vlan 10
[DeviceA-vlan10] port gigabitethernet 1/0/4
[DeviceA-vlan10] quit
# Create VLAN 20, and assign port GigabitEthernet 1/0/5 to VLAN 20.
[DeviceA] vlan 20
[DeviceA-vlan20] port gigabitethernet 1/0/5
[DeviceA-vlan20] quit
# Create Layer 2 aggregate interface Bridge-Aggregation 1.
[DeviceA] interface bridge-aggregation 1
[DeviceA-Bridge-Aggregation1] quit
# Assign ports GigabitEthernet 1/0/1 through GigabitEthernet 1/0/3 to link-aggregation group 1.
[DeviceA] interface gigabitethernet 1/0/1
[DeviceA-GigabitEthernet1/0/1] port link-aggregation group 1
[DeviceA-GigabitEthernet1/0/1] quit
[DeviceA] interface gigabitethernet 1/0/2
Figure 8:
GE1/0/1
GE1/0/2
Link aggregation 1
GE1/0/3
BAGG1
VLAN 10
GE1/0/1
GE1/0/2
GE1/0/3
BAGG1
VLAN 20
40
GE1/0/4
Device B
GE1/0/5