Protocols And Standards; Configuring Basic Vlan Settings - HP A5830 Configuration Manual

When the switch is determining which VLAN a packet that passes through the port should be assigned to,
it looks up the VLANs in the default order of MAC-based VLAN, IP-based VLAN, protocol-based VLAN,
and port-based VLAN.

Protocols and standards

IEEE 802.1Q, IEEE Standards for Local and Metropolitan Area Networks: Virtual Bridged Local Area

Networks

Configuring basic VLAN settings

As the default VLAN, VLAN 1 cannot be created or removed.
You cannot manually create or remove VLANs reserved for special purposes.
To remove:
a protocol reserved VLAN

a management VLAN

a dynamic VLAN

a VLAN with a QoS policy applied

a control VLAN for a smart link group

a control VLAN for an RRPP domain

 a source VLAN for port mirroring
 a remote probe VLAN for remote port mirroring
First remove the configuration from the VLAN, then execute the undo vlan command.
To configure basic VLAN settings:
Step...
1. Enter system view
2. Create VLANs
3. Enter VLAN view
4. Configure a name for the
VLAN
5. Configure the description
of the VLAN
Command...
system-view
vlan { vlan-id1 [ to vlan-id2 ] |
all }
vlan vlan-id
name text
description text
103
Remarks
—
Optional
Use this command to create VLANs in
bulk
Required
By default, only the default VLAN (VLAN
1) exists in the system
If the specified VLAN does not exist, this
command creates the VLAN first
Optional
By default, the name of a VLAN is its
VLAN ID (for example, VLAN 0001)
Optional
VLAN ID is used by default (for example,
VLAN 0001)