HP A5830 Configuration Manual page 168

[PE1] traffic behavior P200
[PE1-behavior-P200] nest top-most vlan-id 200
[PE1-behavior-P200] quit
# Create a QoS policy named qinq, associate traffic class A10 with traffic behavior P100, and associate
traffic class A20 with traffic behavior P200.
[PE1] qos policy qinq
[PE1-qospolicy-qinq] classifier A10 behavior P100
[PE1-qospolicy-qinq] classifier A20 behavior P200
[PE1-qospolicy-qinq] quit
# Enable basic QinQ on the port.
[PE1] interface gigabitethernet 1/0/1
[PE1-GigabitEthernet1/0/1] qinq enable
# Apply QoS policy qinq to the incoming traffic on the port.
[PE1-GigabitEthernet1/0/1] qos apply policy qinq inbound
Configure GigabitEthernet 1/0/2.

# Configure GigabitEthernet 1/0/2 as a trunk port and assign it to VLAN 100 and VLAN 200.
[PE1] interface gigabitethernet 1/0/2
[PE1-GigabitEthernet1/0/2] port link-type trunk
[PE1-GigabitEthernet1/0/2] port trunk permit vlan 100 200
# Create class A100 and configure the class to match frames with CVLAN 10 and SVLAN 100.
[PE1] traffic classifier A100
[PE1-classifier-A100] if-match customer-vlan-id 10
[PE1-classifier-A100] if-match service-vlan-id 100
[PE1-classifier-A100] quit
# Configure traffic behavior T100 to mark matching packets with CVLAN 30.
[PE1] traffic behavior T100
[PE1-behavior-T100] remark customer-vlan-id 30
[PE1-behavior-T100] quit
# Create class A200 and configure the class to match frames with CVLAN 20 and SVLAN 200.
[PE1] traffic classifier A200
[PE1-classifier-A200] if-match customer-vlan-id 20
[PE1-classifier-A200] if-match service-vlan-id 200
[PE1-classifier-A200] quit
# Configure traffic behavior T200 to mark matching packets with CVLAN 40.
[PE1] traffic behavior T200
[PE1-behavior-T200] remark customer-vlan-id 40
[PE1-behavior-T200] quit
# Create a QoS policy named sqinq, associate traffic class A100 with traffic behavior T100, and
associate traffic class A200 with traffic behavior T200.
[PE1] qos policy sqinq
[PE1-qospolicy-sqinq] classifier A100 behavior T100
[PE1-qospolicy-sqinq] classifier A200 behavior T200
[PE1-qospolicy-sqinq] quit
# Apply QoS policy sqinq to the outgoing traffic on the port.
161