Associating Secondary Vlans With An Isolate-User-Vlan; Displaying Isolate-User-Vlan; Setting An Example Isolate-User-Vlan Configuration - HP A5830 Configuration Manual

Associating secondary VLANs with an isolate-user-VLAN

Step...
1. Enter system view
2. Associate the specified secondary
VLANs with the specified isolate-
user-VLAN

Displaying isolate-user-VLAN

Task...
Display the mapping between an isolate-
user-VLAN and its secondary VLANs and
information about these VLANs

Setting an example isolate-user-VLAN configuration

Network requirements
As shown in
 Connect Device A to downstream devices Device B and Device C.
 Configure VLAN 5 on Device B as an isolate-user-VLAN, assign the uplink port GigabitEthernet
1/0/5 to VLAN 5, and associate VLAN 5 with secondary VLANs VLAN 2 and VLAN 3. Assign
GigabitEthernet 1/0/2 to VLAN 2 and GigabitEthernet 1/0/1 to VLAN 3.
Configure VLAN 6 on Device C as an isolate-user-VLAN, assign the uplink port GigabitEthernet

1/0/5 to VLAN 6, and associate VLAN 6 with secondary VLANs VLAN 3 and VLAN 4. Assign
GigabitEthernet 1/0/3 to VLAN 3 and GigabitEthernet 1/0/4 to VLAN 4.
 As far as Device A is concerned, Device B only has VLAN 5 and Device C has only VLAN 6.
Figure 42 Network diagram for isolate-user-VLAN configuration
VLAN 3
Host A
Host B
VLAN 2
Configuration procedure
The following part provides only the configuration on Device B and Device C.
Figure 42,
VLAN 5
GE1/0/5
Device B
Command...
system-view
isolate-user-vlan isolate-user-vlan-id secondary
secondary-vlan-id [ to secondary-vlan-id ]
Command...
display isolate-user-vlan [ isolate-user-
vlan-id ] [ | { begin | exclude | include }
regular-expression ]
VLAN 6
GE1/0/5
Device C
Device A
131
Remarks
—
Required
Remarks
Available in any
view
VLAN 3
Host C
Host D
VLAN 4