Configuring Protocol-Based Vlan - HP A5830 Configuration Manual

Step...
5. Enter
interface
view or
port
group
view
6. Configure the port link type
as hybrid
7. Assign the hybrid port to the
specified protocol-based
VLANs
8. Assign the protocol
template you have created
to the hybrid port

Configuring protocol-based VLAN

Network requirements
In a lab environment, as shown in
the IPv6 protocol for teaching purposes. To avoid interference, isolate IPv4 traffic and IPv6 traffic at Layer
2.
Command...
Enter Layer 2
interface interface-type
Ethernet
interface-number
interface view
Enter Layer 2 interface bridge-
aggregate aggregation interface-
interface view number
Enter port group port-group manual port-
view group-name
port link-type hybrid
port hybrid vlan vlan-id-list
{ tagged | untagged }
port hybrid protocol-vlan
vlan vlan-id { protocol-
index [ to protocol-end ] |
all }
Figure
Remarks
Required.
Use any command:

The configuration made in Ethernet
interface view only applies to the port.

The configuration made in port group
view applies to all ports in the port
group.

The configuration made in Layer 2
aggregate interface view applies to the
aggregate interface and its aggregation
member ports. If the system fails to
apply the configuration to the
aggregate interface, it stops applying
the configuration to aggregation
member ports. If the system fails to
apply the configuration to an
aggregation member port, it skips the
port and moves to the next member
port.
Required.
By default, all ports are access ports.
Required.
By default, a hybrid port is only in VLAN 1.
Required.
39, most hosts run the IPv4 protocol, and the rest of the hosts run
121