HP A5830 Configuration Manual page 180

Step...
3. Enable ARP detection
Configuring an uplink policy
To configure an uplink policy to map a group of CVLANs to one SVLAN:
Step...
1. Enter system view
2. Create a class and enter class
view
3. Configure multiple CVLANs
as match criteria
4. Return to system view
5. Create a traffic behavior and
enter traffic behavior view
6. Configure an SVLAN marking
action
7. Return to system view
8. Create a QoS policy and
enter QoS policy view
9. Map the CVLANs to the
SVLAN by associating the
class with the behavior
Configuring the customer-side port
CAUTION:
Before applying a QoS policy to the customer-side port, enable customer-side QinQ on the port. Before
disabling customer-side QinQ on the customer-side port, remove the QoS policy from the port first.
To configure the customer-side port:
Step...
1. Enter system view
2. Enter Ethernet interface view
3. Configure the port as a trunk
port
4. Assign the port to CVLANs
and SVLANs
Command...
arp detection enable
Command...
system-view
traffic classifier tcl-name operator
or
if-match customer-vlan-id { vlan-id-
list | vlan-id1 to vlan-id2 }
quit
traffic behavior behavior-name
remark service-vlan-id vlan-id
quit
qos policy policy-name
classifier tcl-name behavior
behavior-name mode dot1q-tag-
manipulation
Command...
system-view
interface interface-type
interface-number
port link-type trunk
port trunk permit vlan {
vlan-id-list | all }
173
Remarks
Required
Disabled by default
Remarks
—
Required
Repeat these steps to configure
one class for each group of
CVLANs
Required
Repeat these steps to configure
one behavior for each SVLAN
Required
Required
Repeat this step to create other
CVLANs-to-SVLAN mappings
Remarks
—
—
Required
The default link type of an Ethernet port is
access
Required
By default, a trunk port is in only VLAN 1