Assigning A Vlan Hybrid Port - HP A5830 Configuration Manual

Step...
3. Configure the link type of the
ports as trunk
4. Assign the trunk ports to the
specified VLANs
5. Configure the PVID of the
trunk ports

Assigning a VLAN hybrid port

A hybrid port can carry multiple VLANs. assign it to a VLAN in interface view (including Ethernet
interface view, and Layer 2 aggregate interface view) or port group view.
To change the link type of a port from trunk to hybrid or vice versa, you must set the link type to access
first.
Before you assign a hybrid port to a VLAN, create the VLAN.
After configuring the PVID for a hybrid port, you must use the port hybrid vlan command to configure the
hybrid port to allow packets from the PVID to pass through, so that the egress port can forward packets
from the PVID.
Command...
Enter port port-group manual
group view port-group-name
port link-type trunk
port trunk permit vlan
{ vlan-id-list | all }
port trunk pvid vlan
vlan-id
Remarks
applies to all ports in the port group.

The configuration made in Layer 2
aggregate interface view applies to the
aggregate interface and its aggregation
member ports. If the system fails to apply
the configuration to the aggregate
interface, it stops applying the
configuration to aggregation member
ports. If the system fails to apply the
configuration to an aggregation member
port, it skips the port and moves to the next
member port.
Required.
By default, all ports are access ports.
Required.
By default, a trunk port carries only VLAN 1.
Optional.
By default, the PVID is VLAN 1.
110