Configuring Destination Multicast Mac Address For Bpdus; Bpdu Tunneling Configuration Examples; Configuring Bpdu Tunneling For The Stp Configuration - HP A5830 Configuration Manual

Step...
1. Enter system view
2. Enter
Ethernet
interface
view or port
group view
3. Enable BPDU tunneling for a
protocol
Enabling BPDU tunneling for a protocol in Layer 2 aggregate interface view
To enable BPDU tunneling for a protocol in Layer 2 aggregate interface view:
Step...
1. Enter system view
2. Enter Layer 2 aggregate interface
view
3. Enable BPDU tunneling for a
protocol on the Layer 2 aggregate
interface

Configuring destination multicast MAC address for BPDUs

By default, the destination multicast MAC address for BPDUs is 0x010F-E200-0003.
0x0100-0CCD-CDD0, 0x0100-0CCD-CDD1, or 0x0100-0CCD-CDD2.
For BPDUs to be recognized, the destination multicast MAC addresses configured for BPDU tunneling
must be the same on the edge devices on the service provider network.
To configure destination multicast MAC address for BPDUs:
Step...
1. Enter system view
2. Configure the destination
multicast MAC address for
BPDUs

BPDU tunneling configuration examples

Configuring BPDU tunneling for the STP configuration

Network requirements
As shown in
CE 1 and CE 2 are edges devices on the geographically dispersed network of User A; PE 1 and PE

2 are edge devices on the service provider network.
Enter Layer 2
Ethernet interface
view
Enter port group
view
Command...
system-view
bpdu-tunnel tunnel-dmac mac-
address
Figure 29:
Command...
system-view
interface interface-type interface-
number
port-group manual port-group-name
bpdu-tunnel dot1q { cdp | dldp |
eoam | gvrp | hgmp | lacp | lldp |
pagp | pvst | stp | udld | vtp }
Command...
system-view
interface bridge-aggregation interface-
number
bpdu-tunnel dot1q { cdp | gvrp | hgmp |
pvst | stp | vtp }
97
Remarks
—
Required
Use either command
Required
Disabled by default
Remarks
—
—
Required
Disabled by default
Remarks
—
Optional
0x010F-E200-0003 by default
change it to