HP A5830 Configuration Manual page 167

Configure the edge and third-party devices to allow the voice traffic and data traffic to be

transmitted between the two companies via SVLAN 100 SVLAN 200 separately.
Figure 54 Network diagram for comprehensive selective QinQ configuration
Company A
VLAN 10
Configuration procedure
Make sure that you have configured the switches in the service provider network to allow QinQ packets
to pass through.
Configure PE 1.
1.
 Configure GigabitEthernet 1/0/1.
# Configure GigabitEthernet 1/0/1 as a hybrid port to permit frames of VLAN 100 and VLAN 200 to
pass through untagged.
<PE1> system-view
[PE1] interface gigabitethernet 1/0/1
[PE1-GigabitEthernet1/0/1] port link-type hybrid
[PE1-GigabitEthernet1/0/1] port hybrid vlan 100 200 untagged
[PE1-GigabitEthernet1/0/1] quit
# Create class A10 and configure the class to match frames with CVLAN 10.
[PE1] traffic classifier A10
[PE1-classifier-A10] if-match customer-vlan-id 10
[PE1-classifier-A10] quit
# Create traffic behavior P100 and add the action of inserting outer VLAN tag 100.
[PE1] traffic behavior P100
[PE1-behavior-P100] nest top-most vlan-id 100
[PE1-behavior-P100] quit
# Create class A20 and configure the class to match frames with CVLAN 20. Create traffic behavior
P200 and add the action of inserting outer VLAN tag 200.
[PE1] traffic classifier A20
[PE1-classifier-A20] if-match customer-vlan-id 20
[PE1-classifier-A20] quit
PE 1
GE1/0/2
VLANs 100, 200
TPID = 0x8200
GE1/0/1
Public network
CE 1
VLAN 20
GE1/0/2
GE1/0/1
CE 2
VLAN 30
160
PE 2
Company B
VLAN 40