HP A5830 Configuration Manual page 178

Step...
4. Return to system view
5. Create a traffic behavior and
enter traffic behavior view
6. Configure a CVLAN marking
action
7. Return to system view
8. Create a QoS policy and
enter QoS policy view
9. Associate the class with the
behavior to map the SVLAN
to the CVLAN
Configuring the customer-side port
To configure the customer-side port:
Step...
1. Enter system view
2. Enter Ethernet interface
view
3. Configure the port as a
trunk port
4. Assign the port to
CVLANs and SVLANs
5. Enable basic QinQ
6. Apply the uplink policy to
the incoming traffic
7. Apply the downlink policy
to the outgoing traffic
Configuring the network-side port
To configure the network-side port:
Step...
1. Enter system view
2. Enter Ethernet
interface view
3. Configure the port
as a trunk port
4. Assign the port to
SVLANs
Command...
quit
traffic behavior behavior-name
remark customer-vlan-id vlan-id
quit
qos policy policy-name
classifier tcl-name behavior
behavior-name
Command...
system-view
interface interface-type
interface-number
port link-type trunk
port trunk permit vlan
{ vlan-id-list | all }
qinq enable
qos apply policy
policy-name inbound
qos apply policy
policy-name outbound
Command...
system-view
interface interface-type interface-
number
port link-type trunk
port trunk permit vlan { vlan-id-
list | all }
171
Remarks
Required
Repeat these steps to configure a
behavior for each CVLAN
Required
Required
Repeat this step to create other
CVLAN-to-SVLAN mappings
Remarks
—
—
Required
The default link type of an Ethernet port is access
Required
By default, a trunk port is in only VLAN 1
Required
By default, basic QinQ is disabled
Required
Required
Remarks
—
—
Required
The default link type of ports is access
Required
By default, a trunk port is in only VLAN 1