HP A5830 Configuration Manual page 209

[SwitchB-GigabitEthernet1/0/1] quit
Verify the configuration
3.
# Display the global LLDP status and port LLDP status on Switch A.
[SwitchA] display lldp status
Global status of LLDP: Enable
The current number of LLDP neighbors: 2
The current number of CDP neighbors: 0
LLDP neighbor information last changed time: 0 days,0 hours,4 minutes,40 seconds
Transmit interval
Hold multiplier
Reinit delay
Transmit delay
Trap interval
Fast start times
Port 1 [GigabitEthernet1/0/1]:
Port status of LLDP
Admin status
Trap flag
Polling interval
Number of neighbors:
Number of MED neighbors
Number of sent optional TLV
Number of received unknown TLV : 0
Port 2 [GigabitEthernet1/0/2]:
Port status of LLDP
Admin status
Trap flag
Polling interval
Number of neighbors:
Number of MED neighbors
Number of sent optional TLV
Number of received unknown TLV : 3
As the sample output shows, GigabitEthernet 1/0/1 of Switch A connects to an MED device, and
GigabitEthernet 1/0/2 of Switch A connects to a non-MED device. Both ports operate in Rx mode, and
they only receive LLDPDUs.
# Remove the link between Switch A and Switch B and then display the global LLDP status and port LLDP
status on Switch A.
[SwitchA] display lldp status
Global status of LLDP: Enable
The current number of LLDP neighbors: 1
The current number of CDP neighbors: 0
LLDP neighbor information last changed time: 0 days,0 hours,5 minutes,20 seconds
Transmit interval
: 30s
: 4
: 2s
: 2s
: 5s
: 3
: Enable
: Rx_Only
: No
: 0s
1
: 1
: 0
: Enable
: Rx_Only
: No
: 0s
1
: 0
: 0
: 30s
202