Configuring Destination Multicast Mac Address For Bpdus - HP 5820X series Configuration Manual

Enabling BPDU tunneling for a protocol in Ethernet interface view or port group view
To enable BPDU tunneling for a protocol in Ethernet interface view or port group view:
To do...
1. Enter system view
2. Enter
Ethernet
interface
view or
port
group
view
3. Enable BPDU tunneling for a
protocol
Enabling BPDU tunneling for a protocol in Layer 2 aggregate interface view
To enable BPDU tunneling for a protocol in Layer 2 aggregate interface view:
To do...
1. Enter system view
2. Enter Layer 2 aggregate
interface view
3. Enable BPDU tunneling for a
protocol on the Layer 2
aggregate interface

Configuring destination multicast MAC address for BPDUs

By default, the destination multicast MAC address for BPDUs is 0x010F-E200-0003. Change it to
0x0100-0CCD-CDD0, 0x0100-0CCD-CDD1 or 0x0100-0CCD-CDD2 through the following configuration.
To configure destination multicast MAC address for BPDUs:
To do...
1. Enter system view
2. Configure the destination
multicast MAC address for
BPDUs
For BPDUs to be recognized, the destination multicast MAC addresses configured for BPDU tunneling
must be the same on the edge devices on the service provider network.
Use the command...
system-view
Enter Ethernet interface interface-type interface-
interface view number
Enter port group port-group manual port-group-
view name
bpdu-tunnel dot1q { cdp | dldp
| eoam | gvrp | hgmp | lacp |
lldp | pagp | pvst | stp | udld |
vtp }
Use the command...
system-view
interface bridge-aggregation
interface-number
bpdu-tunnel dot1q { cdp | gvrp |
hgmp | pvst | stp | vtp }
Use the command...
system-view
bpdu-tunnel tunnel-dmac mac-
address
Remarks
—
Required.
Use either command.
Required.
Disabled by default.
Remarks
—
Optional
0x010F-E200-0003 by default
100
Remarks
—
—
Required
Disabled by default