Configuring Destination Multicast Mac Address For Bpdus; Bpdu Tunneling Configuration Examples; Bpdu Tunneling For Stp Configuration Example - HP 3100 Series Configuration Manual

Step
Enter Ethernet interface view or
2.
port group view.
Enable BPDU tunneling for a
3.
protocol.
Enabling BPDU tunneling for a protocol in Layer 2 aggregate interface view
Step
Enter system view.
1.
Enter Layer 2 aggregate interface
2.
view.
Enable BPDU tunneling for a
3.
protocol on the Layer 2 aggregate
interface.
Configuring destination multicast MAC address
for BPDUs
By default, the destination multicast MAC address for BPDUs is 0x010F-E200-0003. You can
change it to 0x0100-0CCD-CDD0, 0x0100-0CCD-CDD1, or 0x0100-0CCD-CDD2.
To configure destination multicast MAC address for BPDUs:
Step
Enter system view.
1.
Configure the destination
2.
multicast MAC address for
BPDUs.
NOTE:
For BPDUs to be recognized, the destination multicast MAC addresses configured for BPDU
tunneling must be the same on the edge devices on the service provider network.

BPDU tunneling configuration examples

BPDU tunneling for STP configuration example

Network requirements
As shown in
•
CE 1 and CE 2 are edges devices on the geographically dispersed network of User A; PE 1 and
PE 2 are edge devices on the service provider network.
Command
system-view
bpdu-tunnel tunnel-dmac
mac-address
Figure 30:
Command
•
Enter Layer 2 Ethernet interface
view:
interface interface-type
interface-number
•
Enter port group view:
port-group manual
port-group-name
bpdu-tunnel dot1q { cdp | hgmp |
lacp | lldp | pvst | stp | udld | vtp }
Command
system-view
interface bridge-aggregation
interface-number
bpdu-tunnel dot1q { cdp | hgmp | pvst |
stp | vtp }
100
Remarks
Use either command.
Disabled by default.
Remarks
N/A
N/A
Disabled by default.
Remarks
N/A
Optional.
0x010F-E200-0003 by default.