Configuring Static Multicast Mac Address Entries; Configuring Igmp Snooping Port Functions - HP 6125G Configuration Manual

For more information about static joins, see
To specify the version of IGMP snooping:
Step
1. Enter system view.
2. Enter VLAN view.
3. Specify the version of IGMP
snooping.

Configuring static multicast MAC address entries

In Layer-2 multicast, a Layer 2 multicast protocol (such as IGMP snooping) can dynamically add multicast
MAC address entries. Or, you can manually configure multicast MAC address entries.
Configuration guidelines
• In system view, the configuration is effective for the specified ports. In interface view, the
configuration is effective only on the current port.
Any legal multicast MAC address except 0100-5Exx-xxxx (where "x" represents a hexadecimal
•
number from 0 to F) can be manually added to the multicast MAC address table. Multicast MAC
addresses are the MAC addresses whose the least significant bit of the most significant octet is 1.
Configuration procedure
To configure a static multicast MAC address entry in system view:
Step
1. Enter system view.
2. Configure a static multicast
MAC address entry.
To configure static multicast MAC address entries in interface view:
Step
1. Enter system view.
2. Enter Layer 2 Ethernet
interface view or Layer 2
aggregate interface view.
3. Configure a static multicast
MAC address entry.

Configuring IGMP snooping port functions

Before you configure IGMP snooping port functions, complete the following tasks:
Enable IGMP snooping in the VLAN.
•
"Configuring static
Command
system-view
vlan vlan-id
igmp-snooping version
version-number
Command
system-view
mac-address multicast
mac-address interface interface-list
vlan vlan-id
Command
system-view
interface interface-type
interface-number
mac-address multicast
mac-address vlan vlan-id
19
ports."
Remarks
N/A
N/A
Version 2 by default
Remarks
N/A
No static multicast MAC address
entries exist by default.
Remarks
N/A
Use either command.
No static multicast MAC address
entries exist by default.