Download Print this page

HP A3100-8 v2 SI Configuration Manual: Enabling Bpdu Tunneling; Configuring Destination Multicast Mac Address For Bpdus

A3100 v2 switch series layer 2 - lan switching.
Hide thumbs

Advertisement

Enabling BPDU tunneling

You can enable BPDU tunneling for different protocols in different views.
NOTE:
Settings made in Ethernet interface view or Layer 2 aggregate interface view take effect only on the
current port. Settings made in port group view take effect on all ports in the port group.
Before you enable BPDU tunneling for HGMP, or STP on a port, disable the protocol on the port.
Because PVST is a special STP protocol, you must do two things before you enable BPDU tunneling for
PVST on a port: first, disable STP; second, enable BPDU tunneling for STP on the port.
Before you enable BPDU tunneling for LACP on a member port of a link aggregation group, remove the
port from the link aggregation group.
Enabling BPDU tunneling for a protocol in Ethernet interface view or port group view
Follow these steps to enable BPDU tunneling for a protocol in Ethernet interface view or port group view:
To do...
Enter system view
Enter
Ethernet
interface
view or port
group view
Enable BPDU tunneling for a
protocol
Enabling BPDU tunneling for a protocol in Layer 2 aggregate interface view
Follow these steps to enable BPDU tunneling for a protocol in Layer 2 aggregate interface view:
To do...
Enter system view
Enter Layer 2 aggregate interface
view
Enable BPDU tunneling for a
protocol on the Layer 2 aggregate
interface

Configuring destination multicast MAC address for BPDUs

By default, the destination multicast MAC address for BPDUs is 0x010F-E200-0003. You can change it
to 0x0100-0CCD-CDD0, 0x0100-0CCD-CDD1, or 0x0100-0CCD-CDD2.
Follow these steps to configure destination multicast MAC address for BPDUs:
To do...
Enter system view
Use the command...
system-view
Enter Ethernet
interface interface-type
interface view
interface-number
Enter port group
port-group manual
view
port-group-name
bpdu-tunnel dot1q { cdp | hgmp
| lacp | pvst | stp | udld | vtp }
Use the command...
system-view
interface bridge-aggregation
interface-number
bpdu-tunnel dot1q { cdp | hgmp |
pvst | stp | vtp }
Use the command...
system-view
90
Remarks
Required
Use either command.
Required
Disabled by default.
Remarks
Required
Disabled by default.
Remarks

Advertisement

   Related Manuals for HP A3100-8 v2 SI

Comments to this Manuals

Symbols: 0
Latest comments: