Servicing Right-Side Components - Arctic Cat WILDCAT X Service Manual

GZ527
Servicing Right-Side
Components
DRIVE CLUTCH
Disassembling

NOTE: Note the timing marks (X) on the cover, spi-
der, and movable sheave. These must be aligned when
assembling the drive clutch for balance purposes.
1. Loosen the machine screws securing the cover.
Remove every other cap screw from the cover; then
while firmly holding the cover, remove the three
remaining screws equally.
WC659
WC658
2. Remove the cover, spring, and nylon shift stop.
64
WC657
WC656A

NOTE: Some models were produced without a shift
stop and instead feature a threaded nut. At this point
on these models, no further disassembling should be
performed. For models with a shift stop, proceed to
step 3.
GZ529
3. Remove the windage plate; then position the drive
clutch over an appropriate clutch holder.

NOTE: The holder should either be secured in a vise
or bolted to a sturdy work bench.