Drive Axles - Arctic Cat WILDCAT X Service Manual

WC722A
9. Install the front seats.

Drive Axles

REMOVING REAR DRIVE AXLE
1. Secure the vehicle on a support stand to elevate the
wheel; then remove the wheel and account for the
hub plate.
WC240B
2. Remove the Belleville washer and hub nut securing
the hub.
WC304
3. Remove the brake caliper.
132
WC268A
4. Remove the hub assembly.
5. Leaving the lower trailing arm connected to the
knuckle, remove the upper trailing arm and lateral
links from the knuckle; then move the top of the
knuckle outward and rotate forward to disengage the
axle from the axle bearing.
WC282B
WC286A
6. Remove the rear axles from the rear drive gear case
by pushing the axle shaft toward the gear case and
pulling the CV/spline shaft out. Account for one
O-ring on each axle shaft.