Servicing Left-Side Components - Arctic Cat WILDCAT X Service Manual

H2-022A
13. Remove the snap ring securing the speed sensor trig-
ger to the shaft; then remove the thrust washer.
Remove the trigger using a suitable "two-jawed"
puller. Account for a gasket.
H2-023
14. Remove the cap screws securing the oil filler cover
to the crankcase; then remove the cover. Account for
an O-ring.
GZ250
Servicing Left-Side
Components
INSPECTING STARTER CLUTCH/GEAR
1. Place the starter clutch gear onto the rotor/flywheel
and attempt to rotate the starter clutch gear clock-
wise. It should lock up to the rotor/flywheel. Rotate
the gear counterclockwise and it should turn freely. If
it moves or locks up both ways, the starter clutch
must be replaced.
58
2. Inspect the starter clutch gear for chipped or missing
teeth or discoloration/scoring of the clutch surface.
Inspect the bearing for loose, worn, or discolored
rollers. If bearing is damaged, it must be replaced.
FI569
3. Inspect the one-way bearing for chipped surfaces,
missing rollers, or discoloration. If any of the above
conditions exist, replace the starter clutch assembly.
FI572
REPLACING STARTER CLUTCH
ASSEMBLY
1. Remove the cap screws securing the one-way clutch
assembly to the flywheel; then remove from the fly-
wheel.
FI570
2. Thoroughly clean the rotor/flywheel; then install the
new starter one-way clutch and secure with the cap
screws after applying a drop of red Loctite #271 to
the threads. Tighten to 26 ft-lb using a crisscross pat-
tern. Make sure the one-way bearing is installed with
the notches directed away from the rotor/flywheel.