Gas Tank - Arctic Cat WILDCAT X Service Manual

Hide thumbs Also See for WILDCAT X:
Table of Contents

Advertisement

WC215A
INSTALLING
1. Connect the throttle cable to the throttle arm; then
install the throttle cable housing to the throttle body
and secure the throttle arm cover with the screw.
2. Make sure the alignment tab on the throttle body
aligns with the slot in the intake boot and install the
throttle body fully into the boot. Tighten the clamp to
30 in.-lb.
WC216A
WC164A
3. Install the wire connectors on the TPS, MAP/IAT,
and TPS; then place the air filter outlet into the throt-
tle body boot and tighten the clamp to 30 in.-lb.
Install the air filter housing strap.
90
WC206B
4. Remove the holding strap and move the radiator
back into position and secure with the mounting
screws. Tighten securely.
5. Secure the heat shield and wiring harness anchors;
then install the cargo box.
6. Install the rear body panel and secure with the appro-
priate fasteners; then connect the negative battery
cable and install the battery cover and seats.
NOTE: If the throttle body, ECM, TPS, or ISC are
replaced, the EFI system must be synchronized. Use
the following procedure.
1. With the key off, depress the accelerator pedal to
Wide Open Throttle (WOT).
2. Place the ignition key in the ON position and wait for
10 seconds.
3. Release the accelerator pedal and wait an additional
10 seconds.
4. Turn the key to the OFF position and allow the gauge
to shut off.

Gas Tank

! WARNING
Whenever any maintenance or inspection is made on
the fuel system during which there may be fuel leakage,
there should be no welding, smoking, open flames, etc.,
in the area.
REMOVING
1. Remove the seats and battery cover; then disconnect
the negative battery cable.
2. Remove the rear body panel and cap off or tape the
gas filler hose.
3. Remove the cargo box; then disconnect the
tail/brakelight connectors and the fuel pump/fuel
level sensor connector.
4. Remove the exhaust pipe to muffler springs and
remove the muffler.
5. Pry the wiring harness anchors out of the cargo box
supports and mark any wire tie locations; then set the
harness out of the way.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Wildcat 4x

Table of Contents