Arctic Cat WILDCAT X Service Manual page 120

WC267A
10. Remove the front drive actuator from the differen-
tial; then remove the front boot clamp from the front
drive coupler and slide the boot off.
WC275A
11. From under the vehicle (X) or inside the vehicle
(4X), slide the driveshaft to the rear sufficiently to
allow differential to move to the rear 6-8 inches.
12. Remove the upper and lower through-bolts; then
slide the differential rearward and lay it on the right
side. Remove from the vehicle from either left or
right side.
WC277
Disassembling Input Shaft
1. Using a T-40 torx wrench, remove the cap screws
securing the pinion housing.
GC004A
2. Using a rubber mallet, remove the housing. Account
for a gasket. Remove the fork, collar, and spring.
Note the location of all the components for assem-
bling purposes.
GC015
CD106
3. Remove the snap rings from the input shaft; then
remove the input shaft from the pinion housing.
GC009A
119