Arctic Cat WILDCAT X Service Manual page 55

GZ193
26. Rotate the crankshaft until the first cap screw (from
step 24) can be addressed; then tighten to 10 ft-lb.
Bend the tab to secure the cap screw.
GZ194
27. Place the C-rings into position in their grooves in the
cylinder heads.
CC012D
28. Install the cylinder head plugs in the cylinder heads
with the open end facing downward and toward the
inside.
CAUTION
The open end of the plug must be positioned downward.
54
GZ162A
29. Remove the cap screw from the end of the chain ten-
sioner; then using a flat-blade screwdriver, rotate the
adjuster screw inside the tensioner clockwise until
the screw bottoms and the adjuster shaft is held in
place.
CD501

NOTE: The adjuster shaft will be drawn into the
tensioner as the adjuster screw is rotated clockwise.
The adjuster shaft tension will be released in step 31.
30. Place the chain tensioner adjuster assembly and gas-
ket into position on the cylinder and secure with the
two cap screws.
CD469
31. Using a flat-blade screwdriver, rotate the adjuster
screw inside the tensioner counterclockwise until the
tensioner spring bears tension; then remove the
screw driver to apply tension to the cam chain.
Install the cap screw into the end of the chain ten-
sioner.