Arctic Cat WILDCAT X Service Manual page 151

WC904
4. Remove the snap ring from the spring retainer, and
remove the spring retainer and the snap ring.
WC906
5. Remove the spring.
ASSEMBLING
1. Slide the spring up to the lock ring.
2. Slide the spring retainer past the snap ring retainer
and secure the snap ring.
WC904
3. Tighten the lock ring until preload is at the measure-
ment noted during cleaning and inspecting; then
tighten the lock ring screw securely.

NOTE: When tightening the lock ring, the spring
retainer must be past the snap ring retainer.
150
WC909
CHECKING/ADJUSTING RIDE HEIGHT
(X Limited/4X Limited)

NOTE: Ensure the vehicle is on level ground, the
tires are properly inflated, and there is an average
operating load in the vehicle.
Front
1. Measure from the ground to the bottom of the outer
frame tube.
WC911A
2. If measurement is not as specified, loosen, but do not
remove, the lock ring screw.
WC914A
3. Adjust the left and right spring as required.
Rear
1. Measure from the ground to the bottom of the frame
at the rear most point.