19. Remove the four cap screws securing the oil strainer
cap; then remove the Phillips-head screws securing
the oil strainer. Account for the O-ring.
AT THIS POINT
To service center crankcase components only, proceed
to Separating Crankcase Halves.
Servicing Right-Side
Components
INSPECTING CENTRIFUGAL CLUTCH
SHOE
Inspect the clutch shoe for uneven wear, chips, cracks, or
discoloration. If wear is present, replace the clutch
assembly.
INSPECTING CENTRIFUGAL CLUTCH
HOUSING
1. Inspect the clutch housing for burns, marks, scuffs,
cracks, scratches, or uneven wear.
2. If the housing is damaged in any way, the housing
must be replaced.
INSPECTING PRIMARY
ONE-WAY DRIVE
1. Place the one-way clutch onto the clutch shoe assem-
bly with the green dot or the word "OUTSIDE"
directed away from the clutch shoe.
MD1337
2. Place
the
shoe/one-way clutch.
MD1208
NOTE: It will be necessary to rotate the clutch
housing counterclockwise to properly seat the
one-way clutch.
3. Check that the clutch shoe can only be rotated coun-
terclockwise in respect to the clutch housing. If the
clutch shoe locks up or turns in both directions, the
one-way clutch must be replaced.
ATV1014
clutch
housing
onto
KC330
the
clutch
KC331A
69