Arctic Cat WILDCAT X Service Manual page 42

GZ026

NOTE: Timing marks on the rotor/flywheel are
stamped with an "F" (front cylinder) and "R" (rear
cylinder) adjacent to the mark.
GZ063
GZ059
2. Remove the tappet covers on the cylinder being ser-
viced. The tappets should not have pressure on them.
3. Loosen the cap screws securing the valve cover to
the cylinder head.
GZ126C
4. Remove all cap screws except the two top-side cap
screws next to the spark plug. These will keep the
alignment pins in place. Note the two rubber washers
on the remaining cap screws.
5. Remove the valve cover. Account for and note the
orientation of the cylinder head plug. Note the loca-
tion of the two alignment pins.
GZ162
GZ132A
6. Remove the cap screw on the end of the tensioner;
then using a flat-blade screwdriver, turn the tensioner
clockwise to remove the tension. Remove the two
cap screws securing the tensioner adjuster assembly
and remove the assembly. Account for a gasket.
GZ405
7. Using an awl, rotate the C-ring in its groove until it is
out of the cylinder head; then remove the C-ring.

NOTE: Care should be taken not to drop the C-ring
into the crankcase.
41