Arctic Cat WILDCAT X Service Manual page 21

7. Remove the steering flex-shaft support bracket; then
slide the EPS unit upwards and to the rear until clear
of the steering rack input coupler.
WC247A
8. Remove the steering flex-shaft coupler from the EPS
unit; then maneuver the assembly past the brake
hoses and out of the vehicle.
WC253A
9. Remove the four cap screws securing the EPS
mounting bracket to the EPS unit.

NOTE: No repairs are authorized on the EPS
assembly and it must be replaced as a complete
assembly.
INSTALLING EPS
1. Install the EPS mounting bracket onto the EPS unit
and secure with the four cap screws. Tighten to 35
ft-lb.
2. Mark the ends of the EPS input and output shafts to
correspond with the flat-splined segment; then align
the flat-splined segment of the output shaft with the
slot in the rack input coupler and install the EPS into
the vehicle.
20
WC254A
WC249A
3. Rock the EPS assembly to seat the splines and
mounting bracket.
WC250A
4. Secure the mounting bracket to the frame and tighten
to 20 ft-lb.
5. Install the steering flex-shaft coupler onto the EPS
input shaft aligning the flat-splined segment of the
shaft to the slot in the coupler.
WC251A