Troubleshooting - Arctic Cat WILDCAT X Service Manual

WC774A
TIRE INFLATION PRESSURE
Front and rear tire inflation pressure should be as speci-
fied in the General Information/Foreword section.
REMOVING
1. Secure the vehicle on a support stand to elevate the
wheels; then remove the hub cap.
2. Remove the nuts securing the wheels; then remove
the wheels.

NOTE: On Limited models, the bead lock must be
removed before attempting to remove the tire from
the rim.

Troubleshooting

Problem: Suspension too soft
Condition
1. Spring preload incorrect
2. Spring(s) weak
3. Shock absorber damaged
Problem: Suspension too stiff
Condition
1. Spring preload incorrect
2. A-arm-related bushings worn
Problem: Suspension noisy
Condition
1. Cap screws (suspension system) loose
2. A-arm-related bushings worn
Problem: Vehicle pulling or steering erratic
Condition
1. Vehicle steering is erratic on dry, level surface
2. Vehicle pulls left or right on dry, level surface
158
CLEANING AND INSPECTING
1. Clean the wheels and hubs with parts-cleaning sol-
vent.
2. Clean the tires with soap and water.
3. Inspect each wheel for cracks, dents, or bends.
4. Inspect each tire for cuts, wear, missing lugs, and
leaks.
INSTALLING

NOTE: On Limited models if a new tire is being
installed, install the bead lock and tighten the existing
screws to 11 ft-lb.
1. Install the wheels and using a crisscross pattern,
tighten the wheel nuts in 20 ft-lb increments to a final
torque of 40 ft-lb (steel wheel), 60 ft-lb (aluminum
wheel w/black nuts), or 80 ft-lb (aluminum wheel
w/chrome nuts). Install the hub cap.
CHECKING/INFLATING
1. Using an air pressure gauge, measure the air pressure
in each tire. Adjust the air pressure as necessary to
meet the recommended inflation pressure.
2. Inspect the tires for damage, wear, or punctures.
! WARNING
Do not operate the vehicle if tire damage exists.

NOTE: If repair is needed, follow the instructions
found on the tire repair kit or replace the tire.
Remedy
1. Adjust preload
2. Replace spring(s)
3. Replace shock absorber
Remedy
1. Adjust preload
2. Replace bushing
Remedy
1. Tighten cap screws
2. Replace bushings
Remedy
1. Check front wheel alignment and adjust if necessary (see
Steering/Body/Controls)
2. Check air pressure in tires and adjust to specifications