Arctic Cat WILDCAT X Service Manual page 88

WC204A
WC206A
13. Install the fuel rail with fuel injectors and secure with
the cap screws. Tighten to 6 ft-lb.
14. Connect the gas line connectors to the fuel rails and
the electrical connectors to the fuel injectors.
WC203A
15. Place the air inlet duct into position; then install the
CVT intake cooling duct and secure with the clamp.
WC209A
16. Set the air filter housing into place and secure with
the three screws on the CVT housing and tighten to 6
ft-lb; then connect and secure the throttle body inlet
air boot (A), crankcase breather hose (B), and inlet
air duct (C). Tighten the intake boot clamp to 30
in.-lb and install the air filter housing strap.
WC146A
17. Install the CVT cooling outlet duct; then with a new
grafoil gasket, install the rear exhaust pipe and cap
screws loosely.
18. Install the radiator/fan assembly and secure with the
mounting screws; then connect and secure the cool-
ant hoses with the clamps. Tighten securely.
19. Connect the fan connectors, rear spark plug cap, and
rear coil primary connector.
20. Install the gas tank cradle and gas tank and secure
with the hold down bracket; then connect the fuel
hose and fuel pump/fuel level sensor connector.
21. Install the heat shield and secure with the appropriate
fasteners; then install the cargo box supports and
secure with the cap screws and new lock nuts.
Tighten to 20 ft-lb.
22. Install the muffler and secure with the spring; then
tighten the front and rear exhaust pipe cap screws to
20 ft-lb.
23. Secure the rear wiring harness to the cargo box sup-
ports as indicated and connect the tail/brakelight
connectors to the light housings.
WC179B
24. Remove the plug on the radiator and fill the radiator
with the recommended coolant allowing air to bleed
from the loosened filler cap; then loosen the bleed
screw on the water pump allowing air trapped in the
engine to escape. Top off coolant and tighten all
bleed points securely.
87