Arctic Cat WILDCAT X Service Manual page 40

WC925A
21. Disconnect the speed sensor connector (D), stator
connector (E), and crankshaft position sensor (F) and
tie the lower harness out of the work space.
WC364A
22. Disconnect the O2 sensor; then remove the exhaust
pipes and account for a grafoil gasket.
23. Remove the upper rear lateral link pivot bolt; then
drop the link down to allow removal of the rear drive
gear case through-bolt.
WC169A
WC170

NOTE: It may be necessary to use a hoist to slightly
raise the rear of the vehicle to free the link from the
frame weldment.
24. Remove two through-bolts and one cap screw secur-
ing the rear drive gear case; then reattach the lateral
link and remove the hoist if used.
WC170A
WC169A
25. Using a suitable engine lift and equalizer sling, sup-
port the engine;
through-bolts, front first followed by the rear.
WC172A
26. Remove the rear drive coupler boot; then lift the
engine slightly and work the rear drive gear case and
engine rearward enough to clear the front drive cou-
pler and drop the driveshaft down.
then remove the engine
39