Cargo Box; Seats - Arctic Cat WILDCAT X Service Manual

WC898A
2. Slide the muffler assembly clear of the holder pins.
Account for the grafoil seal.
INSPECTING
1. Inspect muffler externally for cracks, holes, and
dents.
2. Inspect the muffler internally by shaking the muffler
back and forth and listening for rattles or loose debris
inside the muffler.

NOTE: For additional details on cleaning the muf-
fler/spark arrester,
nance/Tune-Up.
INSTALLING MUFFLER
1. With the grafoil seal in place, place the muffler onto
the holder pins and slide into position.
2. Secure the muffler to the exhaust pipe with the four
exhaust springs.

Cargo Box

REMOVING
1. Remove the rear body panel.
2. Remove the six fender screws (two under rear body
panel) securing the cargo box to the mounts and
remove the cargo box.
WC346B
INSTALLING
1. Set the cargo box into position on the cargo box
mounts; then secure with the six fender screws.
Tighten securely.
see Periodic Mainte-
2. Install the rear body panel.

Seats

REMOVING/INSTALLING (X)
1. To remove a seat, pull the seat lock lever up. Raise
the rear of the seat and tilt it forward.
WC017A
2. To install a seat, slide the front of the seat into the
seat retainers and push down firmly on the rear of
seat. The seat should automatically lock into posi-
tion.
REMOVING/INSTALLING (4X)
1. To remove a front seat, pull the seat lock lever up.
Raise the rear of the seat and tilt it forward.
WC017A
2. To install a front seat, slide the front of the seat into
the seat retainers and push down firmly on the rear of
seat. The seat should automatically lock into posi-
tion.
3. To remove a rear seat, remove two cap screws secur-
ing the seat support to the floor; then remove the
seat.
29