Front Differential - Arctic Cat WILDCAT X Service Manual

GC002A
3. While holding the actuator firmly forward, tighten
the front cap screw to hold the actuator in place; then
install but do not tighten the two remaining cap
screws.
GC001
4. Loosen the front cap screw; then tighten the cap
screw on the driveshaft side.
WC938A

NOTE: It is important to tighten this cap screw
while the others are loose to ensure proper seating of
the actuator.
5. Tighten the remaining cap screws; then connect the
electrical plug to the main harness.
6. Turn the ignition switch to the ON position and
check the operation by shifting the drive select
switch several times.
7. Secure the wiring harness to the frame with a nylon
cable tie; then install the inner fender panel.

Front Differential

REMOVING
1. Remove the forward belly panel (X) or seats and
center console (4X); then drain the lubricant from the
differential.
2. Using an appropriate jack or lift, raise the vehicle so
the wheels are off the floor and support with
jack-stands under the lower A-arms.
WC081D
3. Remove the front wheels and account for the hub
plates; then remove the hub nuts and Belleville
washers.
WC240B
WC304
4. Remove the left and right brake calipers; then
remove the hub/brake disc assemblies.
117