Arctic Cat WILDCAT X Service Manual page 39

WC146A
15. Remove the air filter housing support bracket; then
free the air filter housing from the inlet boot and
remove from the vehicle.
WC365A
16. Disconnect the gas line connectors from the fuel rails
and electrical connectors from the injectors; then
remove the mounting screws and remove the fuel
rails and injectors.
WC203A
17. Remove the ECT connector (A), front coil primary
connector (B), TPS connector (C), TMAP connector
(D), and ISC connector (E); then tie the engine har-
ness out of the way.
38
WC204A
WC206A
18. Remove the engine ground cable.
WC936A
19. Loosen the throttle body boot clamp; then remove
the throttle body leaving the throttle cable attached.
WC210A
20. With the heat shield removed, remove the E-clip (A);
then loosen the jam nut (B) and slide the shift cable
out of the mounting bracket and off the shift arm (C).