Arctic Cat WILDCAT X Service Manual page 53

ATV1027
CAUTION
Care must be taken that the tab-washer is installed cor-
rectly to cover the alignment hole on the sprocket. If the
alignment pin falls out, severe engine damage will
result.
16. Install the first cap screw (threads coated with red
Loctite #271) securing the sprocket and tab-washer
to the camshaft. Tighten only until snug.
GZ195
17. Keeping tension on the opposite cam chain, rotate
the crankshaft until the second cap screw securing
the sprocket to the camshaft can be installed; then
install the cap screw (threads coated with red Loctite
#271) and tighten to 10 ft-lb. Bend the tab to secure
the cap screw.
CAUTION
Failure to keep tension on any loose cam chain may
cause severe engine damage.
GZ193
52
18. Rotate the crankshaft until the first cap screw (from
step 16) can be tightened; then tighten to 10 ft-lb.
Bend the tab to secure the cap screw.
AT THIS POINT

Return the engine to TDC on the front cylinder making
sure the cam lobes are directed downward to ensure
correct starting point for step 19.
19. Keeping tension on the rear cam chain, rotate the
engine forward 270° until rear piston is at TDC indi-
cated by timing mark R.
GZ059
20. With the alignment pin installed in the rear camshaft,
loosely place the cam sprocket (with the recessed
side facing the cam shaft lobes) onto the camshaft.
At this point, do not "seat" the sprocket onto the
shaft.
732-307B
GZ130

NOTE: At this point, oil the camshaft bearings, cam
lobes, and the three seating journals on the cylinder.