Arctic Cat WILDCAT X Service Manual page 119

WC608
5. Holding the upper A-arm/ball joint down into the
knuckle, remove and discard the retaining cap screw.
WC271
6. Raise the upper A-arm to dislodge the ball joint from
the knuckle; then tip the knuckle outward and
remove the axle from the knuckle.
X
WC235
WC272
118
7. Push in on the axle shaft while pulling outward on
the axle coupler and remove the axle assembly from
the differential.
PR729C
8. On the X from underneath the vehicle, remove the
carrier bearing support bracket; then remove the
bolts and nuts securing the carrier bearing to the
bracket and remove the bracket.
WC265A
WC266A
9. Disconnect the drive line coupler by removing three
nuts from the Allen-head bolts; then separate the
drive line to allow the front shaft to move rearward.