Arctic Cat WILDCAT X Service Manual page 70

8. Using an appropriate driven clutch compressor tool,
install the cam making sure all marks are aligned.
Tighten the screws to 11 ft-lb.
WC686
WATER PUMP DRIVE ASSEMBLY
Disassembling
1. Remove the two snap rings from the driveshaft; then
remove the gear and drive pin noting the orientation
of the gear for proper assembly.
GZ442
2. Remove the snap ring securing the bearing in the
water pump drive cover; then remove the bearing
using an appropriate blind bearing remover.
GZ441
Inspecting
1. Inspect the water pump drive housing (A) for scoring
or discoloration.
GZ440A
2. Inspect the bearing (B) for smooth rotation and no
discoloration or scoring.
3. Inspect the gear (C) for chipped or missing teeth,
excessive hub wear, or excessive wear in the drive
pin slot.
4. Inspect the drive pin (D) and driveshaft (E) for
excessive wear or looseness.
Assembling
1. Install the bearing in the water pump drive cover and
secure with the snap ring (flat side away from the
bearing).
GZ441
2. Install the gear onto the driveshaft noting correct ori-
entation (from step 1 of disassembling).
GZ442
3. Install the two snap rings on the driveshaft (flat side
away from the gear).
69