Arctic Cat WILDCAT X Service Manual page 25

WC341A
2. From under the dash, install the lower snap ring onto
the steering shaft.
WC337A
3. Install the wave washer and flat washer onto the
upper steering shaft; then install the upper snap ring.
WC324A
4. Install the upper steering housing collar onto the tilt
housing and tighten the nuts to 20 ft-lb.
WC339A
24
5. Install the steering flex-shaft coupler onto the EPS
input shaft aligning the flat-splined segment of the
shaft to the slot in the coupler; then install the
U-clamp on the lower sheering shaft housing and
secure with two nuts. Tighten to 7 ft-lb.
WC251A
WC252A
WC242
6. Install the upper steering flex-shaft hold-down strap
and secure with the cap screw. Tighten to 50 in.-lb.
WC247A