Smartcard Data Version; Smartcard Data Checksum; Status Mode Time-Out - Emerson unidrive sp User Manual

Parameter Keypad and Parameter
structure display x.00
Gives the type/mode of the data block selected with Pr 11.37 as shown below.
Pr 11.38 String Type/mode
0 FrEE Value when Pr 11.37 = 0
1 3C.SE Commander SE mode parameter file (not used)
2 3OPEn.LP Open-loop mode parameter file
3 3CL.VECt Closed-loop vector mode parameter file
4 3SErVO Servo mode parameter file
5 3REGEn Regen mode parameter file
6-8 3Un Unused
9 4C.SE Commander SE mode difference from default file (not used)
10 4OPEn.LP Open-loop mode difference from default file
11 4CL.VECt Closed-loop vector mode difference from default file
12 4SErVO Servo mode difference from default file
13 4REGEn Regen mode difference from default file
14-16 4Un Unused
17 LAddEr Onboard Application Lite user program file
A file containing user defined data (normally created by an SM-
18 Option
Applications Solutions Module)
11.39

SMARTCARD data version

Drive modes Open-loop, Closed-loop, Servo, Regen
Bit SP
Coding
Range Open-loop, Closed-loop, Servo, Regen
Default Open-loop, Closed-loop, Servo, Regen
Update rate Background read/write
Gives the version number of the data block. This is intended to be used when data blocks are used as drive macros. If a version number is to be
stored with a data block this parameter should be set to the required version number before the data is transferred. Each time Pr 11.37 is changed by
the user the drive puts the version number of the currently viewed data block in this parameter.
11.40

SMARTCARD data checksum

Drive modes Open-loop, Closed-loop, Servo, Regen
Bit SP
Coding
Range Open-loop, Closed-loop, Servo, Regen
Update rate Background write
Gives the checksum of the data block, space left on the card, the total space on the card for the card flags see Pr 11.37 for details.
11.41

Status mode time-out

Drive modes Open-loop, Closed-loop vector, Servo, Regen
Bit SP
Coding
Open-loop, Closed-loop vector, Servo,
Range
Regen
Open-loop, Closed-loop vector, Servo,
Default
Regen
Update rate Background read
Sets the timeout for the drive display to revert to status mode from edit mode following no key presses. Although this parameter can be set to less
than 2s, the minimum timeout is 2s.
Unidrive SP Advanced User Guide
Issue Number: 10
Parameter Advanced parameter
description format descriptions
FI DE Txt VM DP ND
0 to 9,999
0
FI DE Txt VM DP ND
1
0 to 65,335
FI DE Txt VM DP ND
0 to 250 s
240
www.controltechniques.com
Serial comms
Macros
protocol
RA NC NV PT US RW BU
1 1
RA NC NV PT US RW BU
1 1
RA NC NV PT US RW BU
1 1
Electronic
Performance RFC mode
nameplate
PS
1
PS
1
PS
1
Menu 11
213