Fieldbus Module Category Parameters; Solutions Module Error Status Values For Fieldbus Modules - Emerson unidrive sp User Manual

Menus 15 to 17 Parameter Keypad and
Fieldbus structure
5.17.13

Fieldbus module category parameters

Table 5-39 Solutions Module error status values for Fieldbus modules
Error code
0
1
2
SM-PROFIBUS-DP, SM-Interbus,
52
SM-DeviceNet, SM-CANOpen
58
SM-PROFIBUS-DP, SM-Interbus,
61
SM-DeviceNet, SM-CANOpen, SM-SERCOS
62
63
64
SM-PROFIBUS-DP, SM-Interbus,
65
SM-DeviceNet, SM-CANOpen, SM-SERCOS
SM-PROFIBUS-DP
66
SM-CAN, SM-DeviceNet, SM-CANOpen
69
All (except SM-Ethernet, SM-Ether CAT)
70
74
75 SM-Ethernet, SM-Ether CAT
76 SM-Ethernet, SM-Ether CAT
80 All (except SM-SERCOS)
81 All (except SM-SERCOS)
82 All (except SM-SERCOS)
83 All (except SM-SERCOS)
SM-Ethernet, SM-Ether CAT
84
SM-Ethernet, SM-Ether CAT
85
SM-Ethernet, SM-Ether CAT
86
SM-Ethernet, SM-Ether CAT
87
98
99
Below are the parameters that are common to all Fieldbus category modules. For more information, refer to the specific Fieldbus Module User Guide.
x.01 Solutions Module ID code
RO Uni
0 to 599
Update rate: Write on power-up
The menu for the relevant slot appears for the new Solutions Module category with the default parameter values for the new category.
When no Solutions Module is installed in the relevant slot this parameter is zero. When a Solutions Module is installed this parameter displays the
identification code.
401: SM-LON
403: SM-PROFIBUS DP
404: SM-INTERBUS
406: SM-CAN
407: SM-DeviceNet
408: SM-CANOpen
409: SM-SERCOS
410: SM-Ethernet
421: SM-Ethernet CAT
The new parameter values are not stored in the drive EEPROM until the user performs a parameter save by setting Pr xx.00 to 1000 and pressing the
stop/reset button. When parameters are saved by the user in the drive EEPROM, the option code of the currently installed Solutions Module is saved
in the drive EEPROM. If the drive is subsequently powered-up with a different Solutions Module installed, or no Solutions Module is installed when
one was previously installed, the drive will trip on SLx.dF or SLx.nF.
352
Parameter Parameter
display x.00 description format
Module
All
SM-Ether CAT
SM-Ether CAT
SM-LON
SM-Ether CAT
SM-Ether CAT
SM-DeviceNet
SM-CAN
SM-Ethernet
All
All
All
PT US
www.controltechniques.com
Advanced parameter
Macros
descriptions
No trip
No field bus mode has been selected
Critical task over-run
User control word trip
Incorrect non-volatile storage
Configuration error
Database initialisation error
File system initialisation error
Expected packet rate timeout
Network loss
Critical link failure
Bus off error
No acknowledgement
Flash transfer error
No valid menu data available for the module from the drive
Solutions module over temperature
The drive is not responding
The Modbus connection has timed out
Inter-option communications error
Communications error to slot 1
Communications error to slot 2
Communications error to slot 3
Memory allocation error
File system error
Configuration file error
Language file error
Internal watchdog error
Internal software error
Serial comms Electronic
Performance RFC mode
protocol nameplate
Trip Description
Unidrive SP Advanced User Guide
Issue Number: 10