Compactflash Configuration; Compactflash Power Configuration; Clearing Bios Cmos Setup - Kontron CP6500-V User Manual

CP6500-V
4. Configuration
4.1 Jumper Description
4.1.1

CompactFlash Configuration

Table 4-1: CompactFlash Configuration
R199 / J16
Open
Closed
The default setting is indicated by using italic bold.
4.1.2

CompactFlash Power Configuration

Table 4-2: CompactFlash Power Configuration
R215
Open
Closed
The default setting is indicated by using italic bold.
4.1.3

Clearing BIOS CMOS Setup

If the system does not boot (due to, for example, the wrong BIOS configuration, or wrong pass-
word setting), the CMOS setting may be cleared using jumper JP1.
Procedure for clearing CMOS setting:
The system is booted with the jumper in the new, closed position, then powered down again.
The jumper is reset back to the normal position, then the system is rebooted again
Table 4-3: Clearing BIOS CMOS Setup
J21
Open
Closed
The default setting is indicated by using italic bold.
ID 28945, Rev. 01
DESCRIPTION
Configured for master
Configured for slave
R218 DESCRIPTION
Closed 5 V
Open 3.3 V
DESCRIPTION
Normal boot using the CMOS settings
Clear the CMOS settings and use the default values
© 2005 Kontron Modular Computers GmbH
Configuration
Page 4 - 3