Board Overview - Kontron CP6500-V User Manual

Introduction
1.2

Board Overview

1.2.1 Board Introduction
The CP6500-V is a highly integrated CompactPCI board that has been designed to support the
Intel ® Celeron ® processor, which is based on the same core as existing mobile processors. The
CP6500-V utilizes the Intel 815-B0 chipset and the ICH4 I/O Controller Hub. The CPU speed
ranges from 400 MHz through 1 GHz.
To achieve high system performance, the board supports one SODIMM socket for a flexible
memory configuration, up to 512 MB SDRAM memory without Error Checking and Correcting
(ECC).The CP6500-V supports memory speed up to 100 MHz.
The CP6500-V comes with two Fast Ethernet ports, two USB 2.0 ports, two COM ports, two
EIDE interfaces, one PMC interface with 32-bit/33 MHz on the PCI bus (in accordance with the
PICMG 2.3 specification), a Low Pin Count interface (LPC), rear I/O with several interfaces,
one CompactFlash socket, and a built-in Intel 3D Graphics accelerator with a VGA CRT display
interface. Several onboard connectors provide flexible expendability.
The board supports a configurable 32-bit/33 MHz, hot swap CompactPCI interface. In the
System Master slot the interface is enabled, and if installed in a peripheral slot, the CP6500-V
is isolated from the CompactPCI bus.
One of the more important features of the CP6500-V is its support of the PICMG CompactPCI
Packet Switching Backplane Specification 2.16. When installed in a backplane which supports
packet switching, the CP6500-V can communicate via two Fast Ethernet interfaces with other
peripherals.
The board is offered with the Microsoft
Embedded operating systems. Kontron further supports, as a standard, Linux and VxWorks
Please contact Kontron Modular Computers for further information concerning other operating
systems.
Page 1 - 4
® Windows
© 2005 Kontron Modular Computers GmbH
® 2000, Windows ® XP and Windows
CP6500-V
® XP
®
.
ID 28945, Rev. 01