Sending The Signal From An Input Channel To A Mix Bus; Using The Selected Channel Section - Yamaha 007POTO-G0 Owner's Manual

Sending the signal from an input channel to a MIX bus

Sending the signal from an input channel to a MIX bus
Here we will explain how to send the signal of an input channel to MIX buses 1–16.
MIX buses are used mainly to send signals to on-stage foldback speakers or to external effect
processors. Signals can be sent from an input channel to a MIX bus in the following three ways.

■ Using the SELECTED CHANNEL section

In this method, you use the SELECTED CHANNEL section [SELECTED SEND] encoder to adjust the level of
the signal sent to the MIX bus.
This method lets you control the signals sent from a specific input channel to all MIX buses.
■ Using a popup window
In this method, you use the MIX SEND popup window to adjust the send levels from eight channels to a MIX bus.
This method lets you control the send level, on/off setting, and send point for the signals sent from a set of eight
channels to a specific MIX bus.
■ Using the top panel faders
In this method, you switch the LS9 to SENDS ON FADER mode and use the top panel faders to adjust the send
levels to the MIX bus. This method lets you simultaneously control the send levels and on/off switching for the sig-
nals sent from all input channels to a specific MIX bus.
Using the SELECTED CHANNEL sec-
tion
Here's how to use the SELECTED CHANNEL section
[SELECTED SEND] encoder to adjust the level of the
signals sent from a specific input channel to each MIX
bus.
1
Make sure that an output port is assigned
to the MIX bus to which you're sending the
signal, and that a monitor system or exter-
nal effect processor etc. is connected to the
corresponding output port.
Refer to p.95 for details on assigning an output port to
a MIX bus, or to p.42 for details on connecting exter-
nal equipment.
2
Press the SELECTED CHANNEL section
[HOME] key.
The SELECTED CH VIEW screen will appear in the
display.
62
LS9-16/32 Owner's Manual
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
23
1
4
1 TO MIX field
In this field you can switch the on/off status and adjust
the send level of the signal sent from the input channel
to the MIX bus.
B TO MIX LEVEL knob
This adjusts the send level of the signal sent from the
input channel to a VARI type MIX bus. To adjust the
send level in this field, move the cursor to the knob
and use the dial or the [DEC]/[INC] keys.
C TO MIX ON/OFF button
If the send-destination MIX bus is a FIXED type, this
button is displayed instead of the knob
is an on/off switch for the signal sent from the input
channel to a FIXED type MIX bus. To turn the signal
on/off, move the cursor to the button and press the
[ENTER] key.
2 . This button