Inspecting The Shipping Containers For Damage; Unpacking The Server; Verifying The Inventory; Returning Damaged Equipment - HP Integrity rx2800 i4 User Manual

Inspecting the shipping containers for damage

Under normal shipping conditions, HP shipping containers protect the contents. After the equipment
arrives, carefully inspect each carton for signs of shipping damage. Shipping damage constitutes
moderate to severe damage, such as punctures in the corrugated carton, crushed boxes, or large
dents. Normal wear or slight damage to the carton is not considered shipping damage. If you find
shipping damage to the carton, immediately contact your HP customer service representative.

Unpacking the server

1. Follow the instructions printed on the outside top flap of the carton to remove the banding and
the outer carton from the server pallet.
2. Remove all inner accessory cartons and the top foam cushions, leaving only the server.
IMPORTANT:

Verifying the inventory

The sales order packing slip lists all the equipment shipped from HP. Use this packing slip to verify
that all equipment has arrived.
NOTE: To identify each item by part number, see the sales order packing slip.

Returning damaged equipment

If the equipment is damaged, immediately contact your HP customer service representative. The
service representative initiates appropriate action through the transport carrier or the factory and
assists you in returning the equipment.

Unloading the server with a lifter

WARNING!
Use caution when using a lifter. Because of the weight of the server, to avoid injury, you must
center the server on the lifter forks before lifting it off the pallet.
NOTE: HP recommends that you follow your local guidelines when lifting equipment.
1. Unpack the server.
2. Unroll the bottom corrugated tray corresponding to the side on which the lifter is to be placed,
and then slide the server as close to that edge of the pallet as possible.
3. Break off any foam packaging that can prevent the lifter from being fully inserted under the
server. Do not remove the foam packaging from the corners of the server. This foam is required
to elevate the server and to enable the forks of the lifter to be placed under the server.
4. Insert the lifter forks under the server.
5. Carefully roll the lifter forward until it is fully positioned against the side of the server.
6. Slowly raise the server off the pallet until it clears the pallet cushions.
7. Carefully roll the lifter and server away from the pallet. Do not raise the server any higher
than necessary when moving it over to the rack.
HP Confidential
Inspect each carton for shipping damage as you unpack the server.
Server physical and environmental specifications 17