Specifying Scsi Parameters; Using The Scsi Setup Utility - HP Integrity rx2660 User's & Service Manual

2. Use the Arrow keys, Spacebar, and Tab to navigate around the screen and set up the logical
drive, including an online spare drive if one is required.
NOTE:
arrays.
3. Press Enter to accept the settings.
4. Press F8 to confirm the settings and save the new configuration. After several seconds, the
Configuration Saved screen appears.
5. Press Enter to continue. You can now create another logical drive by repeating the previous
steps.
NOTE:
new logical drives available for data storage, format them using the instructions given in
the operating system documentation.

Specifying SCSI Parameters

The following SCSI parameters may be configured for the SCSI board:
• SCSI ID (SCSI initiator ID)
• Maximum data transfer rate (SCSI rate)
• Bus width
• Whether the HBA is bootable (driver support)
• Avoid bus resets (secondary cluster server)
NOTE: Your output might differ from the output in the following examples depending on your
server and its configuration.

Using the SCSI Setup Utility

To use the SCSI Setup Utility to specify SCSI parameters, follow these steps:
You cannot use ORCA to configure one spare drive to be shared among several
Newly created logical drives are invisible to the operating system. To make the
Specifying SCSI Parameters 233