Section 6 - General Specifications & Operator Maintenance; Introduction; Operating Specifications - JLG E600 Operation And Safety Manual

6.1

INTRODUCTION

This section of the manual provides additional necessary infor-
mation to the operator for proper operation and maintenance of
this machine.
The maintenance portion of this section is intended as informa-
tion to assist the machine operator to perform daily maintenance
tasks only, and does not replace the more thorough Preventive
Maintenance and Inspection Schedule included in the Service
and Maintenance Manual.
Other Publications Available:
Service and Maintenance Manual- ANSI, CSA.......................3121117
Service and Maintenance Manual - CE ...................................3121813
Illustrated Parts Manual - ANSI, CSA .........................................3121118
Illustrated Parts Manual - CE........................................................3121814
3121217
SECTION 6 - GENERAL SPECIFICATIONS & OPERATOR MAINTENANCE
SECTION 6. GENERAL SPECIFICATIONS & OPERATOR MAINTENANCE
6.2

OPERATING SPECIFICATIONS

Table 6-1. Operating Specifications - Prior to S/N 0300141450
Maximum Work Load (Capacity)
Unrestricted:
Maximum Travel Grade (Gradeability) with Boom
retracted and approximately horizontal. Tower
Boom fully lowered.
Maximum Travel Grade (Side Slope) with Boom
retracted and approximately horizontal. Tower
Boom fully lowered.
Tilt Alarm Setting (See Section 3)
ANSI, CSA
CE E/M600 & E/M600J
CE E/M 600JP
Maximum Vertical Platform Height:
Maximum Horizontal Platform Reach
E600
E600J
Machine Width
2WD
4WD
– JLG Lift –
500 lb (230 kg)
30%
5°
5°
4°
3°
60 ft. (18.29 m)
43 ft. (13.11 m)
42 ft. 9 in. (13.11 m)
7 ft. 11 7/16 in. (2.42 m)
7 ft. 11 3/8 in. (2.42 m)
6-1