Boom; Swinging The Boom; Raising And Lowering The Upper Boom; Generator (Optional) - JLG E600 Operation And Safety Manual

SECTION 4 - MACHINE OPERATION
4.7

BOOM

DO NOT SWING OR RAISE BOOM ABOVE HORIZONTAL WHEN MACHINE IS OUT OF
LEVEL.
DO NOT DEPEND ON TILT ALARM AS A LEVEL INDICATOR FOR THE CHASSIS.
TO AVOID TIP OVER, LOWER PLATFORM TO GROUND LEVEL. THEN DRIVE MACHINE TO
A LEVEL SURFACE BEFORE RAISING BOOM.
TO AVOID SERIOUS INJURY, DO NOT OPERATE MACHINE IF ANY CONTROL LEVER OR
TOGGLE SWITCH CONTROLLING PLATFORM MOVEMENT DOES NOT RETURN TO THE
'OFF' OR NEUTRAL POSITION WHEN RELEASED.
IF THE PLATFORM DOES NOT STOP WHEN A CONTROL SWITCH OR LEVER IS RELEASED,
REMOVE FOOT FROM FOOTSWITCH OR USE EMERGENCY STOP SWITCH TO STOP THE
MACHINE.
4-8

Swinging the Boom

To swing boom, use SWING control switch to select RIGHT or LEFT
direction.
WHEN SWINGING THE BOOM MAKE SURE THERE IS AMPLE ROOM FOR THE BOOM TO
CLEAR SURROUNDING WALLS, PARTITIONS AND EQUIPMENT.

Raising and Lowering the Upper Boom

To raise or lower the Upper Boom, use Upper Boom Lift switch to
select UP or DOWN movement.
4.8

GENERATOR (OPTIONAL)

Automatic Operating Mode

The generator will operate in automatic mode when:
1. Ground Control EMS is pulled out (on), and:
2. The Generator Enable switch on the platform control con-
sole is in the On or Enable position.
When the above conditions apply, the generator's controller will
monitor status of the batteries, will turn on automatically when
– JLG Lift – 3121217